Model FC, "friction type torque limiter", limit the output of the drive through the friction coefficient of non-asbestos disc applied against the faces of the bearing mounted drive component. The range of transmitted torque is varied by a hexagonal nut applying force to a spring which in turn applies force to the friction discs. During an overload condition, the torque limiter transmits up to the preset value of torque and then allows the output to slip or stop until the overload condition has been corrected. They are built with your specified sprocket, timing belt pulley, v-belt pulley, gear as well as bare for you to supply your own drive component. They are shipped ready to use. Set the torque and install on your drive. When the driven load exceeds the spring and friction pressure on the non-asbestos facings, the clutch will slip and not re-engage until the overload is removed. Available options include: heat treated teeth and shafts for improved wear, needle roller bearings for ultra smooth slip, delrin clutch facings for smooth slip or drags, as well as any OD or LOA modifications necessary for the space available. We will fully customize our product to the needs required for any application.|Protek-Sure Friction Torque Limiter with a 1/2" bore and a 35 Pitch 22 tooth Sprocket with torque set to transmit up to 100 inch pounds ready to install and run.
