Our Products Spring & Detent
Friction Type Torque
Rigid Shaft Couplings Shaft Tensioning
Centrifugal Clutches Process Control, Alarms, Data Collection and Feedback
All Categories > Friction Type Torque Limiters > Model 1FCDC Friction Torque Limiters > View Items  
    Printable Page     Email Email This Page     Save To Favorites Save To Favorites

Model 1FCDC Friction Torque Limiters


Model FCDC, "direct coupling, friction type torque limiter", limit the output of the drive through the friction coefficient of non-asbestos disc applied against the faces of the bearing mounted drive component. The range of transmitted torque is varied by a hexagonal nut applying force to a spring which in turn applies force to the friction discs. During an overload condition, the torque limiter transmits up to the preset value of torque and then allows the output to slip or stop until the overload condition has been corrected. They are built to directly couple the input to the out shafts. They are shipped ready to use. Set the torque and install on your drive. When the driven load exceeds the spring and friction pressure on the non-asbestos facings, the clutch will slip and not re-engage until the overload is removed. Available options include: heat treated teeth and shafts for improved wear, needle roller bearings for ultra smooth slip, delrin clutch facings for smooth slip or drags, as well as any OD or LOA modifications necessary for the space available. We will fully customize our product to the needs required for any application.

  Results 1 - 2 of 2 1 


Product Group/Model

Torque (Max)

Bore Size A

Bore Size B

Design Speed Range

1FCDC-1/2x1/2-3522 Model 1FCDC 1 spring = 25 foot pounds
2 springs = 50 foot pounds
1/2 Inch 1/2 Inch Up to 1800 rpm
1FCDC-1/2x3/4"-NASA Model 1FCDC 1 spring = 25 foot pounds
2 springs = 50 foot pounds
1/2 Inch 3/4 Inch Up to 1800 rpm
  Results 1 - 2 of 2 1 
Copyright © 2012 Hersey Clutch Company., All Rights Reserved     Site created by Thomas Web Solutions and powered by Navigator Platform